Finished basement with a leather sectional, kitchenette with bar stools, recessed lighting and a staircase with iron railings

Legal basement suites in Edmonton: requirements and permits

A legal basement suite in Edmonton is a secondary suite that has been approved and built under permit: a self-contained dwelling with its own living room, kitchen, bedroom and bathroom, its own entrance, and the fire, sound, heating and egress provisions the building code sets for a second home under the same roof. Permits are required for every secondary suite, and the work is inspected at stages before the walls are closed. This guide walks through the requirements as the City of Edmonton publishes them, the documents a permit application needs, and the design decisions that decide whether your basement can become a suite at a reasonable cost. Solenne Homes plans and builds suites as part of our basement development work, and we confirm the current rules for each property at the start.

What counts as a legal secondary suite

The City of Edmonton's secondary suites page defines a suite as a separate dwelling inside a single detached house, semi-detached house, backyard house or row house, with its own living room, kitchen, bedroom and bathroom. A few rules frame everything else:

  • A separate entrance. The suite is entered from a shared indoor landing or directly from outside, without passing through the main home.
  • One suite per home. Only one secondary suite is allowed for each principal dwelling or backyard house.
  • It stays secondary. A suite cannot be split off by condominium conversion or subdivision, and suites are not permitted in apartments.
  • Zoning must allow it. Suites are typically allowed in zones where single detached, semi-detached, backyard houses or row houses are allowed. You can check your lot's zone on Edmonton Maps or with a Development Planner.

A basement with a bedroom, a bathroom and a wet bar that the family uses is not a suite. It still needs permits for the bedroom and bathroom, but not the separations a second dwelling requires. If you are weighing the two, our article on basement development costs in Edmonton compares the budgets.

One more point for late 2026: the City's suite page notes that the Government of Alberta has directed it to amend Zoning Bylaw 20001 by January 22, 2027, focusing on the RS Small Scale Residential Zone and including on-site parking requirements. Zoning details may change while your project is in planning, so confirm the rules for your lot when you apply.

Permits a suite needs

A secondary suite in Edmonton involves several approvals:

  • A development permit, which confirms the suite is allowed under the Zoning Bylaw.
  • A building permit, which confirms the construction meets the Alberta Safety Codes Act and building code.
  • Trade permits for electrical, plumbing, gas, and heating and ventilation work. Homeowners can apply for these only if they live in the home; otherwise a certified trade contractor must apply. An Electrical Inspection Load Calculation form is needed before the electrical permit is issued.

The City is clear that construction should not start until permits are approved, and that starting without them can lead to stop-work orders, fines or penalties. Homeowners can apply themselves or have their contractor apply on their behalf, which is how we normally handle it.

What the application must include

Incomplete applications are a common cause of delay, because City staff cannot begin a review until everything is in. For a suite, the City asks for:

  • A site plan showing the suite entrance, side setbacks to the fence on both sides, a hard-surfaced pathway at least 0.9 metres wide leading to the sidewalk, street or driveway, and a plan for waste collection and storage.
  • A floor plan of the suite with stairs, doors, windows and labelled rooms, bedroom window dimensions and styles, and the heating and ventilation equipment.
  • A sound separation declaration, or clear notes on the floor plan, showing how sound will be controlled between the units.
  • Exterior photographs of all four sides of the house, so staff can see how firefighters would reach the suite.
  • Elevation drawings if you are adding or enlarging windows or exterior doors.
  • Engineer-stamped drawings for structural changes, including new or enlarged openings in foundation walls.

Key design requirements

The City's Secondary Suite Design Guide (the version dated January 31, 2025, based on the National Building Code 2023 Alberta Edition) explains what inspectors look for. It is subject to updates, and the code itself has the final word, but these are the items that shape most basement suites:

  • Ceiling height. Clear height in the suite of at least 1.95 metres, or 1.85 metres under beams and ducts.
  • Bedroom egress. Each bedroom needs an egress window with an unobstructed opening of at least 0.35 square metres and no dimension under 380 millimetres, or an exterior door. A window well must extend at least 760 millimetres in front of the window.
  • Separate heating and ventilation. The suite needs its own independently controlled heating and ventilation system that is not interconnected or ducted with the rest of the house. The guide notes that a heat source alone, without ventilation, is not enough.
  • Smoke and carbon monoxide alarms. Smoke alarms are hardwired and interconnected so that when one sounds, all of them sound. Carbon monoxide alarms are required where the house has an attached garage or fuel-burning appliances, and they are interconnected too.
  • Smoke-tight separation. A continuous barrier of at least 12.7 millimetre (half-inch) gypsum board between the suite and the main home, with solid-core doors at least 45 millimetres thick and self-closers.
  • Sound control. Sound-absorbing insulation in the walls and floor-ceiling between the units, with resilient channel on the prescriptive path, or an assembly with a tested rating.
  • Exterior access. A clear route from the street to the suite entrance that emergency responders can use.

Inspections during construction

All suite permits require inspections, and the permit holder is responsible for booking them. Each trade has its own rough-in inspection. After those pass, a suite built in an existing home needs a "ready-to-cover" building inspection before drywall goes up, so the inspector can see egress windows, stairs, structural changes, alarm locations and sound provisions. The final building inspection comes only after every other inspection has passed. Our article on what renovation schedules leave out explains why inspection timing matters for the overall timeline.

Will your basement work as a suite?

Most of the cost and feasibility questions are answered by the existing house, not the finish list. Before committing to a design, we look at:

  1. Headroom. Low beams and ducts can make the 1.95 metre clear height difficult without moving mechanicals or lowering the floor.

  2. The furnace and ductwork. A suite needs its own system, so the location of the existing equipment and space for a second system matter.

  3. Entrance and path. Side yards, grade and the location of the stairs decide whether a separate entrance and a 0.9 metre path are practical.

  4. Window openings. Enlarging openings for egress is structural work with engineering and excavation.

  5. Moisture. A suite is a home for someone; it has to stay dry, so water issues come first.

When the answers are favourable, a suite can be a good use of space for rental income, extended family or adult children. Our post on renovation ideas that age well covers rough-ins that keep a suite option open even if you build it later.

Frequently asked questions

Do I need a permit for a basement suite in Edmonton?

Yes. The City of Edmonton requires permits for all secondary suites, including a development permit, a building permit and trade permits for electrical, plumbing, gas and heating work. Construction should not start until the permits are approved.

What ceiling height does a legal basement suite need?

The City's Secondary Suite Design Guide lists a clear height of at least 1.95 metres in the suite, or 1.85 metres under beams and ducts. Confirm against the current guide and code for your project.

Does a basement suite need its own furnace?

It needs its own independently controlled heating and ventilation system that is not ducted with the rest of the house. The design guide lists options such as a separate forced-air furnace, or radiant or baseboard heating combined with independent ventilation.

Can I have more than one suite in my house?

No. Only one secondary suite is allowed for each principal dwelling. A building with overlapping dwellings is classed as multi-unit housing and goes through a different permit process.

Plan your suite with us

Solenne is a family-led renovation and custom build company in west Edmonton. Our founder and lead builder, Courtney Parr, brings more than 20 years of construction experience, and our team handles design, drawings, permit applications and inspections as one process. You can see finished basement work in our Windermere basement renovation and our project gallery, and we also build suites with a full bathroom and suite kitchen designed for everyday use. We work across Edmonton neighbourhoods and nearby communities such as Sherwood Park, where the municipality sets its own suite rules. To find out whether your basement can become a legal suite, arrange a consultation and an in-person estimate.